Background

Parts of the design of Phase 22 evolved from Spark and Cha-Osc and also benefit from the experiences designing Prism and Skanner, which are all Reaktor instruments developed at NI. As with Spark and Cha-Osc, the synthesizer uses very basic waveforms — in this case only two sine wave oscillators. But the concept behind Phase 22 is at the same time more radical and more consistent compared to its predecessors. The result is a very symmetrical structure with a core which is reminiscent of a two-operator FM synthesizer.

Spark (2008) & Cha-Osc (2009)
Spark
Cha-Osc
Spark Spark

Spark

Cha-Osc Cha-Osc

Cha-Osc

Phase 22 (2013)
Phase 22
P22 P22

Phase 22

An earlier version of Phase 22 was the basis for the development of Native Instruments' Kontour in 2014. With the learnings from the Kontour project we have improved Phase 22 in many aspects, and it is still evolving as it becomes part of the C15.

Kontour
Kontour
Kontour Kontour

Kontour

About FM and Chaos

(by Stephan Schmitt)

I have always been fascinated by FM synthesis (FM means frequency modulation but in reality, the technique used is phase modulation). John Chowning was the pioneer researcher in this field and Yamaha created the first commercially available instruments.

For a number of years - between the end of the 80's and beginning of the 90's - the Yamaha DX7-II was my main instrument. I also used several other DX/TX/TZ/SY/TG models. These instruments were based on simple building blocks but offered a vast potential for sound programming. The results were not easy to predict but worth the effort. One of their most important advantages was that they could be programmed to respond very expressively to key velocity.

The algorithms of the first FM synths already contained a feedback loop. Later, in NI's FM7 the algorithms were extended to a matrix where every operator's output signal can be sent to any operator's input, allowing even multiple feedback loops. In addition, all these signals can be mixed to the output. We also learned that a filter and a distortion operator make a lot of sense in such structures.

In an earlier stage of the Phase 22 project it was a 4-operator FM synth, but for more simplicity and focus the frequencies of two of the sine oscillators were set to 0 Hz, which means they became sine shapers.

An interesting lesson from "chaos theory" is that even a simple system can behave in a surprisingly complex or "chaotic" way. A good example is a filter with a propagation delay and a non-linear component combined in a feedback loop with enough gain. The non-linear stage could be a wave shaper, or an oscillator with an input for frequency, phase or pulse width modulation or for hard sync.

The design of Spark was inspired by the early Reaktor Ensemble Weedwacker which had a feedback from the output of the filter to the PWM input of the oscillator. Weedwacker fascinated many users because its simple structure was able to produce organic and chaotic sounds.

back to C15 Synth Engine Page